Empower your boat with 120V AC. Choose the right inverter for convenience. Optimize power, enjoy seamless boating.

Inverters bring a new level of enjoyment to your boat. By supplying 120 Volt AC power, inverters allow you to use things such as TVs, other home entertainment equipment, computers, printers, microwaves, and power tools when away from shore power and without using a generator. They can also recharge dead cell phones or hand-held VHF batteries with AC chargers. They can enable you to use AC entertainment equipment instead of buying 12 volt or battery powered equipment, which is more costly. Also, generally AC power tools are not only less expensive but also more powerful than battery powered tools. Choosing the right size inverter depends on many factors, but it’s generally better to get one too big than “just right” or too small.

120 Volt AC power on board usually comes from three sources: shore power, a generator, or an inverter. Assuming you don’t want to stay tethered to the dock, your choice between a generator or an inverter depends on your power requirements underway. Typically today, many boaters have both a generator and inverter aboard. They complement each other nicely.

Generators produce large quantities of continuous power, ideal for running air conditioners, large freezers, and other high-load, long-duration applications. They also can charge the ship’s batteries through a marine rated AC battery charger. (See the article Battery Charger.) The downside is that generators require fuel, an exhaust system and maintenance of both the generator’s engine and the generator itself, which its engine powers. (Some generators are run by the boat’s propulsion engine, but most are attached to and run by a separate dedicated engine.) Also their AC output often is not as stable as what you get in your home because ofperiods of rough running, spikes and surges. For example, an impurity in the fuel supply can cause aberrant running and therefore a spike or surge in the electricity. This can cause serious damage to sophisticated users such as, for example, computers or printers. Although modern technology has improved generators, they do consume space, vibrate, and may not be very quiet.

When AC power needs are smaller or you don’t want an internal combustion engine going, inverters have a number of advantages. They are an economical, maintenance-free, and relatively compact source of AC power, and the inverter’s solid state circuitry is quiet and non-intrusive. Although many inverters produce a modified sine wave, not the true sine wave of a generator or shore power, the power from these inverters is adequate to run many electronic and motor-driven appliances. True sine wave inverters are also available. They are more expensive but run more things and are less likely to cause long term harm to the devices that use them. Some printers and other devices will not run on modified sine wave at all. So many prefer to spend the few extra bucks and get an inverter that produces a true sine wave.

Generators and inverters are not incompatible, and many generator owners also have an inverter on board. The generator provides the muscle to charge batteries and power a high demand air conditioner, for example, while the inverter can silently run the TV or small microwave or brew a cup of coffee in a quiet harbor.

Whether an inverter, generator or a combination of both is the best solution for you depends on your power needs, preferences, your boat and an understanding of how inverters work.

What Inverters Do

Inverters operate somewhat like battery chargers in reverse: they take DC power from a battery and, utilizing sophisticated circuitry, change it into 120 Volt AC current. The ship’s batteries are the inverter’s fuel tank and, by nature, inverters can consume a lot. They will only provide 120 Volt AC power as long as there is ample juice left in the 12 Volt batteries. It is strongly recommended that you have a separate, dedicated engine starting battery to avoid accidentally draining the entire 12v system. (See the article 12 Volt Electrical Systems)

Because inverters and battery chargers share certain electrical components, many models are available as combination inverter/charger units. Most automatically switch almost seamlessly to battery charger mode when plugged into shore power or if the generator is turned on, changing back almost seamlessly into an inverter mode when the AC power input is turned off. Most models have multi-stage chargers that prolong the life of your batteries by monitoring them and altering the charge rate according the battery’s needs and condition. Since overcharging and poor charging are among the leading causes of death among batteries, this is an important feature. Also, some inverter chargers can be set to optimally charge specific banks. You can program them as to ambient temperature, battery temperature, bank size, battery type and other factors. This is a very desirable feature.

Larger inverter/chargers not only have smart three stage charging but can also supply very high DC charging output if needed by the batteries. This is important because, there is power lost when inverters change DC to AC, not merely in proportion to the DC generated, but also because of efficiency issues in the process. The more AC power produced by the inverter, the greater the DC loss attributable to a low efficiency. Look for the efficiency rating when buying. If you have an inverter/charger that can supply high amperage, “intelligently” to your batteries when charging, you can turn off your generator earlier and go back to quiet power.

Choosing An Inverter

Before you can select the appropriate inverter, you must first analyze your power needs, including future additions. The key is to determine the maximum amount of 120 Volt AC power you and your crew will use at any one time, keeping in mind efficiency issues and the fact that the more you use the sooner you’ll discharge the battery bank if you have no charging source, such as a generator or engine alternator, running. Small inverters will operate one or two smaller appliances simultaneously. If you want to run the TV, VCR, and computer in the salon while a crew makes microwave popcorn, you’ll need a larger capacity unit.

Inverters are typically rated by maximum continuous watts. The most accurate way to figure the watts you might use is to check the data plate on each 120 Volt AC appliance you plan to have on board. Be aware that some items can vary in wattage significantly depending on the setting chosen. Also note that most motor-driven equipment such as blenders and power tools draw a power surge for a few seconds at start up. Modern inverters generally accommodate such momentary surges as long as you don’t switch everything on at the same time.

To determine the proper inverter size for your boat, make a list or spreadsheet of all the 120vAC equipment you will run, adding its wattage in a second column. If the appliances data plate states the power in amps, convert to watts using this formula:

Volts x Amps = Watts

i.e. an item stated at 120 volts and 3 amps will draw 360 watts.

Add the wattage of all the appliances that you want to operate simultaneously, making sure you include any items, such as a refrigerator, that run continuously. The total wattage run at one time is the minimum size inverter you should consider. However you should always purchase at least one size larger. You will probably discover more uses for your inverter after you’ve installed it — and if you turn too many loads on at the same time, the inverter will overheat and shut down. Also adding up power requirements on labels of devices does not include efficiency loss and loss of voltage (resulting in increased amp draw) through wire runs and possible resistance in connections and elsewhere.

We mentioned startup power surges. Transformer inverters (these have large coils of wire inside) may handle these surges better than inverters using other more sophisticated technology. But these are larger and may be considerably heavier, although the cost is usually smaller.

Choosing Batteries To Power The Inverters

Inverters depend on adequate type, size and number of ship’s batteries for proper operation. To estimate the size and number of batteries you’ll need, expand your list of appliance wattages by adding a third column for the amount of time you’ll want to run each piece of gear in a 24-hour day. Since battery capacity is measured in amp hours, you’ll need to build a forth column for adding up the amp hours required. Convert the watts to amp hours using this formula:

AC Watts ÷ 12v x 1.1 x Hours Use=Amp hours

Example: the 13″ TV uses 50 watts and you want to use it 2 hours each day, so 50/12 x 1.1 x 2 = 9 amp hours. If the data plate lists AC amps rather than watts, use this formula:

AC Amps x 10 x 1.1 x Hours of Use = Amp hours

When your chart is complete, (see example below) you will see immediately which appliances are going to pull the most juice out of the batteries. Note that it isn’t always the high draw items that cause problems — the blender may draw six times the watts of the TV, but since its use is short, the TV has a much larger total. Now is a good time to reconsider high draw items, especially those with heating elements such as toasters, hair dryers, and waffle irons. You probably will not want to run these on an inverter, rather wait until the generator is on or until you’re charging your batteries with an engine driven alternator.

In our example, a total of 397 amp hours is required to meet the power needs from the inverter in 24 hours. But the inverter’s draw of 12 Volt DC from the battery to supply that AC demand will be more because of the efficiency loss, the energy required by the inverter to do its job and other factors. (Your inverter specifications should give you relevant information as to this.) And you shouldn’t draw down the batteries too low, and battery efficiency may be quite low depending on their age, the temperature and how well they’ve been charged and maintained. Therefore more battery power will be needed than the simple total. At a minimum you would want to add 50% more battery capacity for a total of 596 amp hours. Be aware that batteries age and die faster if “cycled,” (discharged and recharged) frequently and even faster if cycled deeply (with deep discharges). Many battery manufacturers recommend that you double the needed capacity to avoid premature destruction of batteries — in our example this would result in a bank with 794 amp hours. There are several different types of batteries that perform well but differently. These include wetted lead acid (old fashioned but these were what powered submerged submarines before nuclear power, and still do on some subs), gel cell, AGM and others. Development of improved batteries is ongoing actively and before you buy you should investigate to learn about the latest products out there and what’s most likely to suit your needs.

When constructing your appliance list, don’t forget that the demands from the inverter aren’t the only items your batteries have to handle. They still have to keep pace with all the 12 Volt DC users such as lights, electric head, water pumps, electronics and other systems. Also, the appliance list won’t include power lost due to lack of efficiency and wire runs.

Inverter Options

Just as you monitor your car’s fuel gauge, you must be aware of the status of your batteries. Most inverter manufacturers offer excellent remote panels, some with sophisticated battery monitoring systems. A few of the features available include low battery alarm, overload warnings, current in and out and the number of amp hours consumed — all on a panel mounted in a conveniently visible location.

Every amp hour drawn out of the batteries must be replaced. If your boat has a generator or you plug into shore power at the end of each day, this may be of less concern. If you anchor for more than a few days without a generator, however, methods of replacing the batteries’ expended juice must be considered. High-output alternators on the main engine, wind generators and solar panels can all be arranged to keep the system supplied with enough energy, depending on your usage. Although remember that running the main engine for long periods of time merely to power the high output alternator isn’t very good because there isn’t sufficient load on the engine.

All inverter installations require a large, dedicated 12 Volt fuse in the main power line from the battery to the inverter. Be sure to purchase the correct fuse block and fuse with the inverter — it’s always wise to carry a spare fuse if you plan a long term cruise. It is very important to follow carefully all the instructions in installation and operating the inverter. Larger inverters can consume a lot of DC power at times, and the wiring must be as specified by the manufacturer, not only to promote efficiency, but also to avoid fires and melt downs. A good unit will have a thorough set of instructions. Remember also that AC power from an inverter can cause fatal electric shock, just as it can if it’s the shore power or generator. Proper wiring and circuit breakers and all other aspects of installation and operation, according to applicable ABYC (American Boat and Yacht Council) standards is important. And post warnings in appropriate places that, although the boat isn’t “plugged in” wires and components may still be hot with AC current.

Technology, knowledge and practices change almost daily therefore it is prudent to research for the very latest up to the date information and seek qualified professional assistance when needed.

BoatUS Editors

Contributor, BoatUS Magazine

About Vessel Vanguard

Vessel Vanguard is a leading marine safety and maintenance management software provider dedicated to revolutionizing the maritime industry. With a commitment to innovation and excellence, Vessel Vanguard delivers cutting-edge solutions to streamline operations and enhance vessel performance and safety.

Latest Industry Insights


Embracing E-Boating Efficiencies

Eyeing an electric boat but not quite ready to take the plunge? Here are some ways ...
Yacht charging and fueling up.

Boat Fuel Systems

At the spring boat shows, as you’re looking at new boat models, ask about the fuel ...

The Future of Boats & Boating

BoatUS Magazine editors predict what recreational vessels — and boating in general — will look like ...
Yacht Navigation Light Inspection

Yacht Navigation Light Inspection

I’ve never understood why so many vessels I inspect as a marine surveyor fail in their ...

View All of Our Industry Insights

Navigate maritime with the latest news, practical how-to guides, insightful analyses and more.